Seal for making soap, snowman

Seal for soaps, snowman:

How to apply seals for soaps:

The surface of the soap should be completely smooth and flat so that the two millimeters of the seal are completely embedded. It is preferable to mark the seal for soaps "snowman", on freshly made soap, because, over time, it becomes dehydrated, and becomes more difficult to mark, since it hardens.

If the soap is too soft, it will stick. And if, on the contrary, it was very dry, it would not penetrate well, the edges would break and the result would not be satisfactory.

Once the seal is placed, where we want to mark it, we must press evenly, until the base of the seal stops with the same soap. Then, remove it slowly.

Maintenance of seals for soaps:

You can clean it with soap and water, but never with hot water, as the heat could soften and deform the seal material. Nor in the dishwasher.

You can also use a small brush or a wooden toothpick, between sealing and sealing, in case there is soap stuck in a hole in the seal.

Have you never used a seal for soaps? Well, we have a tutorial on our blog Make Soaps that will come great. Stop by the blog and discover our article on how to use the soap seal.